Excerpt: ...tube in this case is used as a generator of oscillations. CHAPTER XIV HEADPHONES AND LOUD SPEAKERS Wireless Headphones.-A telephone receiver for a wireless receiving set is made exactly on the same principle as an ordinary Bell telephone receiver. The only difference between them is that the former is made flat and compact so that a pair of them can be fastened together with a band and worn on the head (when it is called a headset), while the latter is long and cylindrical so that it can be held to the ear. A ...
Read More
Excerpt: ...tube in this case is used as a generator of oscillations. CHAPTER XIV HEADPHONES AND LOUD SPEAKERS Wireless Headphones.-A telephone receiver for a wireless receiving set is made exactly on the same principle as an ordinary Bell telephone receiver. The only difference between them is that the former is made flat and compact so that a pair of them can be fastened together with a band and worn on the head (when it is called a headset), while the latter is long and cylindrical so that it can be held to the ear. A further difference between them is that the wireless headphone is made as sensitive as possible so that it will respond to very feeble currents, while the ordinary telephone receiver is far from being sensitive and will respond only to comparatively large currents. How a Bell Telephone Receiver Is Made.-An ordinary telephone receiver consists of three chief parts and these are: (1) a hard-rubber, or composition, shell and cap, (2) a permanent steel bar magnet on one end of which is wound a coil of fine insulated copper wire, and (3) a soft iron disk, or diaphragm, all of which are shown in the cross-section in Fig. 62. The bar magnet is securely fixed inside of the handle so that the outside end comes to within about 1/32 of an inch of the diaphragm when this is laid on top of the shell and the cap is screwed on. Illustration: Fig. 62.-Cross-section of Bell telephone Receiver. Illustration: original (c) Underwood and Underwood. Alexander Graham Bell, Inventor of the Telephone, now an ardent Radio Enthusiast. The ends of the coil of wire are connected with two binding posts which are in the end of the shell, but are shown in the picture at the sides for the sake of clearness. This coil usually has a resistance of about 75 ohms and the meaning of the ohmic resistance of a receiver and its bearing on the sensitiveness of it will be explained a little farther along. After the disk, or diaphragm, which is generally made of thin, soft sheet iron...
Read Less
Add this copy of The Radio Amateur's Hand Book to cart. $19.72, new condition, Sold by Ingram Customer Returns Center rated 5.0 out of 5 stars, ships from NV, USA, published 2022 by Legare Street Press.
Add this copy of The Radio Amateur's Hand Book to cart. $25.44, new condition, Sold by Revaluation Books rated 4.0 out of 5 stars, ships from Exeter, DEVON, UNITED KINGDOM, published 2018 by CreateSpace Independent Publishing Platform.
Add this copy of The Radio Amateur's Hand Book to cart. $27.91, good condition, Sold by Bonita rated 4.0 out of 5 stars, ships from Newport Coast, CA, UNITED STATES, published 2018 by CreateSpace Independent Publis.
Add this copy of The Radio Amateur's Hand Book to cart. $29.16, new condition, Sold by Ingram Customer Returns Center rated 5.0 out of 5 stars, ships from NV, USA, published 2022 by Legare Street Press.
Add this copy of The Radio Amateur's Hand Book: a Complete, Authentic to cart. $33.66, good condition, Sold by Bonita rated 4.0 out of 5 stars, ships from Newport Coast, CA, UNITED STATES, published 2008 by Forgotten Books.
Add this copy of The Radio Amateur's Hand Book: a Complete, Authentic to cart. $33.97, new condition, Sold by Revaluation Books rated 4.0 out of 5 stars, ships from Exeter, DEVON, UNITED KINGDOM, published 2008 by Forgotten Books.
